amjaiin writes " Hi all,
I am a new user in Fluent. I want to simulate a vertical water jet in 2D in the presence of gravity and air. For this I made the geometry as such: a rectangle grid with the bottom edge as a wall and side edges as pressure outlets. The upper edge is also a pressure outlet except for a small edge, representing the jet, which is a velocity inlet. Will this configuration work?
In fluent, I am using the k-eplison model with the gravity option and the operating media as air.
But when I am simulate the jet using this model, I don't get the result I expect (it gives some upward motion after few cms).
Please suggest some changes I should make to correct the model.
Thanks,
Amit"
| 
]
